
New Orleans Concreters pours new concrete driveways and driveway replacements across River Ridge, a quiet residential community in Jefferson Parish. You get a local crew, honest itemized pricing, and concrete prepped, jointed and sealed to hold up through southeast Louisiana's heat, humidity and soft ground.
New driveways & full replacements
Whether you are replacing a cracked, heaving driveway or pouring new, we build it to carry real vehicle loads: a compacted base, the right slab thickness and rebar or wire reinforcement where it counts, with proper slope so water runs off instead of pooling.
Finishes & options
- Broom finish for a durable, classic driveway.
- Stamped or bordered for curb appeal that matches a stamped patio or walkway.
- Exposed aggregate for grip and a high-end look.
- Proper drainage and expansion joints so the slab moves without cracking.
Built for the Gulf Coast climate
An properly proportioned mix, correct jointing and a good sealer keep your driveway intact through heat, heavy rain and shifting soils. We will tell you honestly whether a repair or a full replacement is the smarter spend.
Concrete driveways in River Ridge
We pour and replace concrete driveways across River Ridge, near the Elmwood business park, on a compacted base at the right thickness for the soft ground. River Ridge is unincorporated Jefferson Parish, so structural flatwork generally needs a Jefferson Parish permit while simple paving often does not. We confirm and handle it.
Concrete work in River Ridge
River Ridge is unincorporated Jefferson Parish on the east bank of the Mississippi. The land was developed in the late 18th century for French colonial sugar plantations, and the area was officially named River Ridge in 1974. Parts of River Ridge are just blocks from Kenner's Rivertown historic district.
What the ground in River Ridge means for your slab
River Ridge is mapped mostly as Schriever clay, with Cancienne silt loam on natural levee ground near the river. Schriever is a poorly drained, very slowly permeable clay with very high shrink-swell that NRCS rates very limited for streets, while Cancienne is somewhat poorly drained and rated only somewhat limited, mainly for low strength. In general, flatwork on soils like these depends on a well-compacted base, grading that sends water away from the slab, and control joints placed to manage cracking.
Permits in River Ridge
Jefferson Parish's Building Permits Department (formerly Inspection and Code Enforcement; East Bank office, 1221 Elmwood Park Blvd., 504-736-6957) lists paving of walkways, driveways and other non-structural paving on private property as exempt from a building permit, though some zoning districts require paving review. Sidewalks, driveway aprons and curb cuts in the parish right-of-way need a permit from the Department of Engineering (504-736-6500). A driveway on a state highway needs a Louisiana DOTD permit.
Why River Ridge homeowners choose us
- Built on a real base so it does not crack, heave or settle a year later.
- Sealed for the Gulf Coast climate against heat, heavy rain and shifting soils.
- Honest, itemized pricing, in writing, before we start.
- Local crew that answers the phone and shows up when we say.
Serving River Ridge and nearby
We cover River Ridge and nearby Metairie, Kenner, Gretna, Harvey, Marrero, plus the rest of the New Orleans area. Wherever you are within about 30 miles of New Orleans, the standard is the same.
Common questions
How much does a concrete driveway cost?
Driveway cost depends on square footage, thickness, reinforcement, tear-out of the old slab, and finish. We give a clear, itemized estimate for free so there are no surprises.
How thick should a concrete driveway be?
Four inches is standard for cars; we go thicker where trucks, RVs or heavy loads are involved, with reinforcement to match.
Can you replace just part of my driveway?
Often yes. If only a section has failed we can replace that area; if the base is gone underneath the whole thing, a full replacement is the better value. We will tell you straight.
Do I need a permit to replace the driveway apron at the street?
Yes, when the apron is on parish right-of-way. Jefferson Parish requires a driveway permit from the Department of Engineering for any new, replacement or additional driveway apron, and that permit also covers the public sidewalk. Engineering can be reached at 504-736-6500; replacement driveways can also be discussed at 504-349-5174. If the street is a state highway, the permit comes from Louisiana DOTD instead.
Do I need a building permit for a new driveway on my River Ridge property?
Jefferson Parish lists driveways and other non-structural paving on private property as exempt from a building permit, unless the Code Official finds a hazardous or complex condition, and some zoning districts require paving review. The apron and sidewalk in the parish right-of-way do need a Department of Engineering permit (504-736-6500).
