
In River Ridge, a quiet residential community in Jefferson Parish, New Orleans Concreters handles concrete slabs and foundations from the base up. We look at drainage and the ground first, then give you a written, itemized estimate before any forms go in.
Flat, square, and to spec
Garage slabs, shed pads, addition and outbuilding foundations, and equipment pads, poured level and square on a compacted base with the reinforcement the job calls for. We also pour basement and warehouse floors.
Built to carry the load
- Compacted base and proper thickness for the use.
- Rebar or wire reinforcement where needed.
- Correct slope and jointing to control cracking.
Concrete work in River Ridge
River Ridge is unincorporated Jefferson Parish on the east bank of the Mississippi. The land was developed in the late 18th century for French colonial sugar plantations, and the area was officially named River Ridge in 1974. Parts of River Ridge are just blocks from Kenner's Rivertown historic district.
What the ground in River Ridge means for your slab
River Ridge is mapped mostly as Schriever clay, with Cancienne silt loam on natural levee ground near the river. Schriever is a poorly drained, very slowly permeable clay with very high shrink-swell that NRCS rates very limited for streets, while Cancienne is somewhat poorly drained and rated only somewhat limited, mainly for low strength. In general, flatwork on soils like these depends on a well-compacted base, grading that sends water away from the slab, and control joints placed to manage cracking.
Permits in River Ridge
Jefferson Parish's Building Permits Department (formerly Inspection and Code Enforcement; East Bank office, 1221 Elmwood Park Blvd., 504-736-6957) lists paving of walkways, driveways and other non-structural paving on private property as exempt from a building permit, though some zoning districts require paving review. Sidewalks, driveway aprons and curb cuts in the parish right-of-way need a permit from the Department of Engineering (504-736-6500). A driveway on a state highway needs a Louisiana DOTD permit.
Why River Ridge homeowners choose us
- Built on a real base so it does not crack, heave or settle a year later.
- Sealed for the Gulf Coast climate against heat, heavy rain and shifting soils.
- Honest, itemized pricing, in writing, before we start.
- Local crew that answers the phone and shows up when we say.
Serving River Ridge and nearby
We cover River Ridge and nearby Metairie, Kenner, Gretna, Harvey, Marrero, plus the rest of the New Orleans area. Wherever you are within about 30 miles of New Orleans, the standard is the same.
Common questions
How thick should a slab be?
It depends on the load. Shed and patio slabs are thinner than garage or equipment pads. We size thickness and reinforcement to the use.
Can you pour a slab for a garage or addition?
Yes, garage slabs, addition foundations, shed pads and outbuilding floors are all standard work for us.
Do I need a permit to replace the driveway apron at the street?
Yes, when the apron is on parish right-of-way. Jefferson Parish requires a driveway permit from the Department of Engineering for any new, replacement or additional driveway apron, and that permit also covers the public sidewalk. Engineering can be reached at 504-736-6500; replacement driveways can also be discussed at 504-349-5174. If the street is a state highway, the permit comes from Louisiana DOTD instead.
Do I need a building permit for a new driveway on my River Ridge property?
Jefferson Parish lists driveways and other non-structural paving on private property as exempt from a building permit, unless the Code Official finds a hazardous or complex condition, and some zoning districts require paving review. The apron and sidewalk in the parish right-of-way do need a Department of Engineering permit (504-736-6500).
